Your Boundary
Scan Test
Hardware
Accessory Center
|
- Our Boundary Scan test hardware products, allow
Test Engineers to further proliferate the use of DFT
and Boundary Scan Techniques, through low cost,
flexible, IEEE standard hardware test options.
Increase test coverage and make your design engineers
test point insertion effort easier!!!!!
And with the NEW Scan Test Cable Adapters from
JEK-Tech(tm), you can stop requesting signal pinouts that
match your Boundary Scan tester, instead of your
designers device programming system.....
|
The AccessExtender(tm) increases test access and coverage!
The AccessExtender(TM) 100
Supports 0.8v to 5.0v test signals
JEK Technical Services, LLC
3 Delta Drive
Nashua, NH 03060-5823
Phone : 603-791-4233
FAX : 603-791-4606
Copyright ©2006 JEK-Technical Services, LLC.
Still trying to access those connectors from a Bed of Nails?
Worried about the actual Connector Solder Joint?
Why worry about intermittent connections due to board flexure during
flying probe testing?
